BabySploit is a penetration testing toolkit aimed at making it easy to learn how to use bigger, more complicated frameworks like Metasploit. With a very easy to use UI and toolkit, anybody from any experience level will find use out of BabySploit. Below are some screenshots of the framework.
BabySploit is best run out of the home directory so to clone it there run:
git clone git://github.com/M4cs/BabySploit ~/BabySploit cd ~/BabySploit
After cloning the installation you must install some pre-requisites. If you are on Kali you should already have all of these installed but it doesn’t hurt to do so anyways just in case. Do so by running the following:
If you are not on Kali you need to add the Kali repository to your APT Sources list and then run install.
~- From Within The BabySploit Directory -! sudo apt-get update sudo apt-get upgrade sudo python3 install.py virtualenv babysploit source babysploit/bin/activate pip3 install -r requirements.txt python3 start.py !- To Leave The Virtual Environment -! deactivate
Setting Configuration Values
BabySploit uses ConfigParser in order to write and read configuration. Your config file is automatically generated and located at
./babysploit/config/config.cfg. You can manually change configuration settings by opening up the file and editing with a text editor or you can use the set command to set a new value for a key. Use the set command like so:
set rhost >> Enter Value For rhost: 10 >> Config Key Saved!
If before running this command the rhost key had a value of 80, the rhost key after running this command has a value of 10. You can also add configuration variables to the config by using the set command with a new key after it like so:
set newkey >> Enter Value For newkey: hello >> Config Key Saved!
Before running this there was no key named “newkey”. After running this you will have a key named “newkey” in your config until you use the
reset command which resets the saved configuration.
Running A Tool
In order to run a tool all you have to do is enter the name of the tool into BabySploit. You can use the
tools command to display a menu with all the currently availble tools. If we run tools we get the depiction:
This menu will display the tools available and the description of each tool. To run a tool simply enter the tool name into BabySploit. Ex:
ftpbruteforce – runs the ftpbruteforce tool.